Activation key sold by resellers or distributors

Activation key sold by resellers or distributors

When a reseller or a distributor sells an MSoft license, TechMed’s team must be advised in order to generate the license activation key. Please write to sales@techmed3d.com and support@techmed3d.com to advise TechMed’s team.

 

Please make sure to include the following information in the email in order to generate the license:

  1. End user’s full name
  2. End user’s email address
  3. End user’s company name
  4. End user’s company address

 

Once received, TechMed’s support team will generate the license key and advise the end user as well as the reseller involved. If needed, training and installation will be planned along with the end user and TechMed’s support team.


    Still need help?

    Contact us at support@techmed3d.com!

      • Related Articles

      • Using the Token Supplier

        The token supplier is a tool that is used to distribute tokens from a main license key to children license keys and to monitor subscription licenses you are sending to your customers. A token license uses tokens every time a file from any scanner is ...

      • Step by step guide to use MSoft’s compare module

        Available directly within MSoft, the compare module is a fantastic tool. You can see the same body part, before and after your intervention, side by side or even overlapped. This allows you to validate that the orthosis had the effect that you were ...

      • Foambox Processing in MSoft

        There are a few key points to processing a foam box in MSoft to avoid errors leading to a bad reconstruction. First, make sure the scan was made with the good scan mode : foam box (negative imprint). You can ensure the right mode was used by looking ...

      • Processing a head scan with MSoft in 3 easy steps

        First, align your scan. Aligning your scan with the 4 Views will indicate to MSoft which are the front, left or right side and top of your model. Click and rotate the model until every view is properly oriented. Second, reconstruct your model. The ...

      • Processing an AFO scan with MSoft in 3 easy steps.

        First, align your scan. Aligning your scan will indicate to MSoft where are the toes, the heel and the floor. Adjust the view and identify, respecting this order: the first metatarsal head, the fifth metatarsal head and the heel. Second, clip your ...