Setup and subscription

Setup and subscription

First Usage

When the application is opened for the first time, a window will appear. It might look different as the one pictured below, but the information requested will be the same:


 

Fill the required information and click on the Register button.

This will trigger a notification on Qwadra’s end to approve or decline this registration. Until it is approved, a similar message will appear in the application.

 

Setup or Subscription for validation

To register the right users and activate the license on our side, we will need the following information if possible:

·      Company name: Your company name

·      Contact name: Someone we can contact if needed

·      Phone number

·      Email

·      Serial number of the Structure Sensor (on the box): The serial number of the scanner used

If the information cannot be confirmed on your end, the end user might need to confirm with you that they registered so that you can confirm with us.

Once approved, you will be able to use the app to its full potential.



    Still need help?

    Contact us at support@techmed3d.com!

      • Related Articles

      • Step by step guide to use MSoft’s compare module

        Available directly within MSoft, the compare module is a tool that can show the same body part, before and after your intervention, side by side or even overlapped. This allows you to validate that the orthosis had the effect that you were aiming ...

      • Foambox Processing in MSoft

        There are a few key points to processing a foam box in MSoft to avoid errors leading to a bad reconstruction. First, make sure the scan was made with the good scan mode : foam box (negative imprint). You can ensure the right mode was used by looking ...

      • Processing a knee scan with MSoft in 4 easy steps.

        First, align your scan. Aligning your scan with the 4 Views will indicate to MSoft which are the front, left or right side and top of your model. Click and rotate the model until every view is properly oriented. Second, clip your scan. Clipping your ...

      • Processing an elbow scan with MSoft in 4 easy steps.

        First, align your scan. Aligning your scan using the 4 Views function will indicate to MSoft where is the front, the left or right side ,and top of your model. Click and hold to rotate the model until every view is properly oriented. Second, clip ...

      • Processing a head scan with MSoft in 3 easy steps

        First, align your scan. Aligning your scan with the 4 Views will indicate to MSoft which are the front, left or right side and top of your model. Click and rotate the model until every view is properly oriented. Second, reconstruct your model. The ...